路由器综合路由配置 配置三层交换机 www.2cto.com Switch>enableSwitch#conf tEnter configuration commands, one per line. End with CNTL/Z.Switch(config)#vlan 2Switch(config-vlan)#exitSwitch(config)#
路由器综合路由配置 配置三层交换机 www.zhishiwu.com Switch>enable Switch#conf t Enter configuration commands, one per line. End with CNTL/Z. Switch(config)#vlan 2 Switch(config-vlan)#exit Switch(config)#interface fastEthernet 0/2 Switch(config-if)#switchport access vlan 2 Switch(config-if)#no shutdown Switch(config-if)#exit Switch(config)#interface vlan 1 Switch(config-if)#ip address 192.168.1.1 255.255.255.0 Switch(config-if)#no shutdown Switch(config-if)#exit Switch(config)#interface vlan 2 %LINK-5-CHANGED: Interface Vlan2, changed state to up Switch(config-if)#ip address 192.168.2.1 255.255.255.0 Switch(config-if)#no shutdown Switch(config-if)#end Switch#show ip route Switch#enable Switch#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Switch(config)#router rip Switch(config-router)#network 192.168.1.0 Switch(config-router)#network 192.168.2.0 Switch(config-router)#version 2 配置R1 www.zhishiwu.com Router>enable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#interface fastEthernet 0/0 Router(config-if)#ip address 192.168.2.2 255.255.255.0 Router(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up Router(config)#interface fastEthernet 1/0 Router(config-if)#ip address 192.168.3.1 255.255.255.0 Router(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet1/0, changed state to up Router(config-if)#exit Router(config)#router rip Router(config-router)#network 192.168.2.0 Router(config-router)#version 2 Router(config-router)#exit Router(config)#router ospf 1 Router(config-router)#network 192.168.3.0 0.0.0.255 area 0 配置R2 Router>enable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#interface fastEthernet 0/0 Router(config-if)#ip address 192.168.3.2 255.255.255.0 Router(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up Router(config-if)#exit Router(config)#interface fastEthernet 1/0 Router(config-if)#ip address 192.168.4.1 255.255.255.0 Router(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet1/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet1/0, changed state to up Router(config-if)#exit Router(config)#router ospf 1 Router(config-router)#network 192.168.3.0 0.0.0.255 area 0 Router(config-router)#network 192.168.4.0 0.0.0.255 area 0
（免责声明：文章内容如涉及作品内容、版权和其它问题，请及时与我们联系，我们将在第一时间删除内容，文章内容仅供参考）
